贵州森时达电力电气有限公司贵州森时达电力电气有限公司

开关柜厂家
森时达电力:配电柜安装规范及注意事项

森时达电力:配电柜安装规范及注意事项

发布日期:2018-02-01 作者:贵阳开关柜厂 点击:

森时达电力:配电柜安装规范及注意事项

SSDA power: distribution cabinet installation specification and precautions

贵州开关柜厂

  配电柜安装规范及注意事项,贵州开关柜厂家为你解说。

  Installation specification and precautions of distribution cabinet

  首先注意里面的桥架安装横平竖直,附件按标准设置。配电柜布置成排成列,配电柜相互间或与基础型钢间要用镀锌螺栓连接,且防松零件齐全。高低压柜立面、背面平整,水平度、垂直度好,操作通道宽敞。正面要有盘面编号,背面也应注明编号。内部接线整齐,表识正确。接线端子要有编号;

  First, the installation of the bridge is horizontal and vertical, and the accessories are set according to the standard. The distribution cabinets are arranged into rows, and the distribution cabinets are connected to each other or with the base type steel with galvanized bolts, and the anti loose parts are complete. The high and low pressure cabinet is flat on the side, the back is flat, the level, the perpendicularity are good, and the operation channel is spacious. The front should be numbered and the back should be numbered on the back. The internal wiring is neat and the knowledge is correct. The terminals should be numbered.


1决不允许任何给排水管通过;

1 no drains shall be allowed to pass through;

2变压器低压侧的中性点直接与接地干线连接,基础型钢接地;

2 the neutral point of the low voltage side of the transformer is connected directly with the grounding trunk line, and the base type steel is grounded.

3电缆终端头、接头、拐弯处及竖井的两端要设标志牌;

3 the end of the cable terminal, the joint, the turning point and the shaft of the shaft should be marked on both ends。

4配电柜应有公共型钢底座,整体布局整齐,柜内接线正确、可靠。地沟电缆走在支架上排列整齐,分段捆扎,有挂牌,接地排布置规范标识清晰,绝缘档鼠板合理设置。

4 the distribution cabinet should have the common steel base, the whole layout is neat, the wiring in the cabinet is correct and reliable. The trench cable is arranged on the bracket, the section is tied up, and there is a hanging card. The layout of the grounding arrangement is clear and the insulation mouse board is set reasonably.


贵州森时达电力电气有限公司 电桥架设置规范,接地保护可靠,电缆进柜合理受力均匀,外保护好。变电所内,高低压配电设备及裸母线的正上方,不应安装灯具。

 The electric bridge frame is set standard, the grounding protection is reliable, the cable cabinet is reasonably stressed, and the external protection is good. In the substation, the high and low voltage distribution equipment and the bare bus bar should not be installed.


1配电室与隔墙或楼板的所有空洞均应做防火密闭封堵。

1 all the holes in the distribution room and the partition wall or floor should be closed and closed with fireproof。

贵州森时达电力电气有限公司2配电柜长度大于6米,背后要有两个出口,且最小宽度为1米

2 the distribution cabinet is more than 6 meters in length, and there will be two exits in the back, and the minimum width is 1 meters.

3门口必须安装挡鼠板。

The 3 door must be fitted with a mouse plate。

4配电柜前工作区要铺橡胶板

4 the front work area of the distribution cabinet should be paved with rubber plate

5柜箱盘线间、线对地间绝缘电阻馈电线路大于0.5兆欧,二次回路大于1兆欧。线缆整齐。

The insulation resistance feed line between 5 cabinets and lines is greater than 500 billion Europe, and the two circuit is more than 1 Mega。 The cable is neatly。

  贵州森时达电气集团,华中领先的高低压开关柜,箱式变压器厂家。打造华中电气成套第一品牌。

贵州森时达电力电气有限公司Guizhou Sen Da electric group, central China high low voltage switch cabinet, box transformer manufacturer. To build the first brand of China Central Electric complete set.


本文网址:http://www.ylfsk.com/news/361.html

相关标签:贵阳开关柜厂

最近浏览:

上虞防水补漏有限公司 青州市瑞青农林科技有限公司 贵州森时达电力电气有限公司浙江盾安人工环境股份有限公司 聊城市坚美金属制品有限公司 庆元菇星节能机械有限公司 东莞市易升仪器有限公司 天山网 青岛正茂包装有限公司 南通沪南科学仪器有限公司 临朐县荣亨金属制品厂